HVAC in Ogden, UT
Locally owned Ogden heating and air businesses, each checked against the same published standard. Below the list: Utah's new HVAC license, when Ogden needs a permit, and which rebates are still open in 2026.
No hvac listed yet. We're reviewing applications now and only list businesses that pass every check, so this page stays empty until one does.
Run a heating and air business in Ogden? Apply for one of the ten slots.
What Utah requires of an HVAC contractor
Utah changed HVAC licensing in 2026. DOPL now has an H100 HVAC Contractor license, with new requirements that began April 20, 2026. Its qualifier must hold RMGA certification or an equivalent and two years of HVAC-specific experience. The business must carry liability insurance of $1 million per occurrence and $2 million in aggregate. State law now defines HVAC as including "the gas line".
Older licenses used the S350 HVAC classification, which excluded natural gas work. If a contractor shows you an S350, ask how they're handling the gas side of the job, and check the license yourself in the state's Licensee Lookup and Verification System.
Gas work needs certification, whoever does it
Utah requires anyone who installs, repairs, cleans or replaces a residential gas appliance or combustion system to be trained and certified first. That applies to licensed contractors and to people who are otherwise exempt. A handyman doing a job under $7,000 can't touch your furnace or gas water heater unless they hold that certification.
When Ogden needs a permit
Ogden City requires a permit to alter, change, extend, install, repair or replace a mechanical or natural gas system, and names furnace replacement specifically. For an owner-occupied home, the homeowner or a Utah-licensed contractor can pull it. Ogden Building Permits and Inspections is at 2549 Washington Blvd, 801-629-8950.
Sizing a system for Ogden
Ogden City publishes the design figures it accepts for heating and cooling load calculations (Manual J). The outdoor winter design temperature is 5°F and the summer design temperature is 97°F. Indoors it's 70°F for heating and 75°F for cooling, at an elevation of 4,350 feet, with 6,012 heating degree days.
That matters because the most common HVAC mistake is the wrong size. An oversized furnace or AC short-cycles: it runs in short bursts, wears faster and controls humidity poorly. Ask whether the quote is based on a load calculation for your house or on the size of the old unit.
Rebates and credits in 2026
The federal credits are gone. The IRS says the 25C energy efficient home improvement credit isn't allowed for anything placed in service after December 31, 2025. Utah's federally funded Home Energy Rebate program is on hold.
Gas utility rebates are still open. Dominion Energy's Utah gas business is now Enbridge Gas, and its ThermWise program lists:
- $300 for a furnace rated 95% to 97.4% AFUE, or $350 for 97.5% or higher with an ECM motor
- $50 or $75 for a qualifying smart thermostat
- $700 to $1,200 for a dual-fuel heat pump, by efficiency tier
- Attic insulation from $0.32 per square foot, and duct sealing or insulation up to $450
Rebate requests must be postmarked within six months of installation.
Rocky Mountain Power filed updated Wattsmart Homes incentives in January 2026 covering heat pumps, central air, smart thermostats, duct sealing and insulation. The amounts depend on regulators, so check Rocky Mountain Power's Wattsmart page for what's currently offered before you count on a figure.
The refrigerant change
Federal rules now cap the climate impact of refrigerants in new home air conditioners and heat pumps. In May 2026 EPA said there's no installation deadline for systems whose specified components were all made or imported before January 1, 2025. So some older-stock R-410A equipment can still be installed, but most new systems use newer refrigerants. Ask which one your quote uses, because it affects future service and parts.
What HVAC work costs in Ogden
We don't publish installation prices, because we haven't found a dated local survey we'd stand behind. The labor baseline: the Bureau of Labor Statistics puts the median wage for HVAC mechanics and installers in the Ogden area at $28.44 an hour (May 2025). That's what technicians earn, not the rate you're billed.
What moves the price:
- Equipment efficiency. A 97% furnace or a cold-climate heat pump costs more up front and less to run, and it's what the rebates reward.
- Ductwork. Leaky or undersized ducts in older Ogden homes can cancel out a better furnace. Duct sealing is rebated separately.
- Venting and gas line changes. High-efficiency furnaces vent differently from older ones.
- Timing. A no-heat call in January costs more than a planned replacement in September.
How to choose an HVAC contractor
- Check the license. Look for an active H100 (or S350 with a certified gas subcontractor).
- Ask for a load calculation rather than a like-for-like swap.
- Confirm the permit is included for a furnace or AC replacement.
- Ask which rebates apply and who files the paperwork.
- Get a written contract for a full replacement, with the equipment model numbers listed.
Every HVAC business listed here has been checked for a real Ogden-area address, local ownership, a Utah license and insurance. See how we vet.
HVAC questions
Do I need a permit to replace a furnace in Ogden?
Yes. Ogden City says a permit is required to replace a roof, furnace or water heater, and to alter or replace any mechanical or natural gas system. A licensed HVAC contractor normally pulls it as part of the job.
Can a handyman replace my furnace?
Not legally, unless they hold the right gas certification. Utah's handyman exemption for jobs under $7,000 says installing, repairing or replacing a gas appliance or combustion system must be done by someone certified under Utah Code 58-55-308(2).
Is the federal tax credit for furnaces and heat pumps still available?
No. The IRS says the 25C energy efficient home improvement credit is not allowed for property placed in service after December 31, 2025. Utah's federally funded home energy rebate program is also on hold.
Can I still have an R-410A air conditioner installed?
Only in limited cases. After EPA's May 2026 change, there is no installation deadline for systems where all the specified components were made or imported before January 1, 2025. New equipment generally uses lower-impact refrigerants. Ask your contractor which refrigerant the quoted system uses.